Search SunshineGlass.com
Sunshine is your Stained Glass Source! THE AQUA FLOW SYSTEM
FROM TECHNIGLASS

HOME > SHOPPING INDEX > TOOLS > QUICK FIT BITS

04/02/22


 

 

 

 

 

TOP OF PAGE

 

AQUA FLOW SYSTEM
The Aqua Flow System uses a special brush to apply water directly to your bit.

  • Applies a constant flow of water to your grinding bit

  • Won't dry out, won't clog up with sludge

  • Bristles will constantly clean the grinder bit

  • Maximizes the grinder bit life

INSTALLATION AND USE
When starting to grind or when the grinder has been idle for a while, splash a few drops of water over the brush bristles. This will hydrate the brush to start grinding
  • Discard Sponge
     

  • Remove grinder work surface
     

  • Install grinder bit on the shaft
     

  • Slide brush on to the Aqua Flow holder

  • Snap the self-locking holder between the grinder shaft and the reservoir back wall
    The Aqua Flow Brush will be touching the grinder bit
     

  • Fill the reservoir with water.
    There needs to be at least 1/8" of water in the reservoir to properly work.
     

  • Align the grinder work surface over the Aqua Flow brush and grinder bit
    Set the work surface in place and you are ready to go!
     

To maintain optimum performance of your Aqua Flow System, every once in a while, wash the brush and holder with warm water to remove any excess debris.
CHOOSE THE RIGHT AQUA FLOW SYSTEM FOR YOUR GRINDER
All Packages include the AFS Holder and two brushes.
Refill brushes are found below
If you have:
  • Glastar Diamond Star
  • Glastar Super Star

Order # TG AFS D/S  $16.99

If you have:
  • Glastar All Star G-8

Order # TG AFS A  $16.99

If you have:
  • Inland Wiz
  • Inland Wizling
  • Inland Wizard

Order # TG AFS I  $16.99

If you have:
  • Techniglass THE Grinder
  • Techniglass THE Grinder 2

Order # TG AFS TG  $16.99

REFILL BRUSHES
Sold in a pack of three, these brushes will fit all of the AFS systems shown above

Order # TG AFS B  $14.99

SPECIAL NOTE

The Aqua Flow System will not fit:

  • Inland Impulse or other Inland Touch Top Grinders

  • Inland Twin Spin or other flat disk grinders

  • ANY Gryphon model

  • Glastar Starlet G-5

  • Older Glastar and other models from the 80's and 90's

 

back to top

SHOP HOURS
CLICK HERE TO SEE OUR SHOWROOM AND ORDER DESK HOURS
  HOME SALE ITEMS NEW PRODUCTS  
  SHOPPING INDEX NEWSLETTER DIRECTIONS & MAP  
  REQUEST OUR CATALOG SEARCH PRIVACY  


Sunshine Glassworks Ltd.
Sunshine Square, 111 Industrial Pkwy, Buffalo, NY 14227
1-800-828-7159 or 1-716-668-2918 or fax to 1-716-668-2932

All contents and illustrations are 1997 thru 2019 by Sunshine Glassworks Ltd.